WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
10.3.3.15 LLDP
Table 137: CLI "LLDP" Configuration
Node
enable
enable
configure
configure
configure
interface
Manual
1.1.0
Command
show lldp
show lldp neighbor
lldp (disable | enable)
lldp tx-interval
lldp tx-hold
lldp-agent (disable |
enable | rx-only | tx-only)
Description
This command displays the LLDP configurations.
This command displays all information of port
neighbors.
This command globally enables / disables the LLDP
function on the switch.
This command configures the transmission interval
for LLDP packets.
This command configures the "tx-Hold Time" that
determines the TTL of the switch message. (TTL =
tx-hold * tx-interval)
This command configures the Agent function for
LLDP.
"disable":
LLDP is enabled for
a specific port.
"enable":
The LLDP packet is transmitted
on a specific port and
received.
"tx-only":
The LLDP packet is only
transmitted
on a specific port.
"rx-only":
The LLDP packet is only received
on a specific port.
Appendix
277