Table 154: Cli "Snmp" Configuration; Management - WAGO 852-1305 Manual

290 Appendix
10.3.6

Management

10.3.6.1 SNMP

Table 154: CLI "SNMP" Configuration

Node
enable
configure
configure
configure
configure
configure
configure
Example
L2SWITCH#configure terminal
L2SWITCH(config)#snmp enable
L2SWITCH(config)#snmp community public rw trusted-host 192.168.200.106/24
L2SWITCH(config)#snmp trap-receiver 192.168.200.106 v2c public
L2SWITCH(config)#snmp system-contact IT engineer
L2SWITCH(config)#snmp system-location Wago
Command
show snmp
snmp community
STRING (ro | rw) trusted-
host IPADDR
snmp (disable | enable)
snmp system-contact
STRING
snmp system-location
STRING
snmp system-name
STRING
snmp trap-receiver
IPADDR VERSION
COMMUNITY
WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
This command displays the SNMP configurations.
This command configures the "SNMP Community"
name.
This command disables / enables SNMP on the
switch.
This command configures contact information for
the system.
This command configures the location information
for the system.
This command assigns a name to the system.
This command configures the trap receiver's
configurations, including the IP address, version (v1
or v2c) and "Community".
Manual
1.1.0