Table 157: Cli "Maintenance" Configuration; Wago-Ethernet-Zubehör - WAGO 852-1305 Manual

292 Appendix
10.3.6.4 Maintenance

Table 157: CLI "Maintenance" Configuration

Node
configure
configure
configure
configure
configure
configure
Example
L2SWITCH#configure terminal
L2SWITCH(config)#interface eth0
L2SWITCH(config-if)#ip address 172.20.1.101/24
L2SWITCH(config-if)#ip address default-gateway 172.20.1.1
L2SWITCH(config-if)#management vlan 1
Command
reboot
reload default-config
write memory
archive download-config
<URL PATH>
archive upload-config
<URL PATH>
archive download-fw
<URL PATH>
WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
This command reboots the system.
This command resets the system configuration to the
default settings.
Note: The system automatically reboots to apply
the configurations.
This command writes the current operating
configurations to the configuration file.
This command downloads an updated configuration
file from TFTP server.
Where <URL PATH> can be:
ftp://user:pass@192.168.1.1/file
http://192.168.1.1/file
tftp://192.168.1.1/file
This command uploads the current configurations
file to the TFTP server.
This command downloads an updated firmware file
from the TFTP / FTP / HTTP server.
Where <URL PATH> can be:
ftp://user:pass@192.168.1.1/file
http://192.168.1.1/file
tftp://192.168.1.1/file
Manual
1.1.0