Table 79: Wbm "Lldp" Page - "Settings" Tab - WAGO 852-1305 Manual

WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Table 79: WBM "LLDP" Page – "Settings" Tab
LLDP Settings
Parameters
State
Tx Interval
TX Hold
Time To Live
Port
State
LLDP Status
Parameters
Port
State
Manual
1.1.0
Configuring in the Web-Based Management System (WBM)
Default
Disable
Enable
30
4
120
From: 1
To: 1
Enable
Rx Only
Tx Only
Disable
Default
1 ... 10
Disable
Enable
Description
Select "Disable" in the selection box to disable this
function.
Select "Enable" in the selection box to enable the
LLDP function. for the switch globally.
Enter the value for the "Tx Interval" (transmission
interval) for the LLDP packets in the input field.
Enter the value for the "tx-Hold Time" in the input
field that determines the TTL of the switch's
message.
(TTL = tx-hold * tx-interval)
This field displays the lifetime for the switch's
information.
Select a port or port range in the selection box for
which you want to configure the "LLDP" setting.
Select a port or port range in the selection box for
which you want to configure the "LLDP" setting.
In this selection box, select "Enable" to enable the
LLDP function on individual ports.
Select the "Rx Only" setting in the selection box if
"Rx Interval" is always used as the transmission
interval for the switch or ports.
Select the "Tx Only" setting in the selection box if
"Tx Interval" is always used as the transmission
interval for the switch or ports.
In this selection box, select "Disable" to disable the
LLDP function on individual ports.
Description
This column displays the port numbers.
This column displays if "LLDP" is enabled or
disabled.
193