Table 105: Wbm "Traffic Monitor" Page - WAGO 852-1305 Manual

WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX

Table 105: WBM "Traffic Monitor" Page

Traffic Monitor Settings
Parameters
Status
Port
State
Action
Packet Type
Packet Rate (pps)
Recovery State
Recovery Time (min)
Traffic Monitor Status
Parameters
Port
State
Status
Packet Type
Packet Rate (pps)
Recovery State
Recovery Time (min)
Pos : 28.8.8 /Serie 852 (ETH ERNET-Z ubehör)/Konfigurieren/M anagement 852- 0303 @ 27\mod_1468318199599_21.doc x @ 216542 @ 234554533344433 @ 1
Manual
1.1.0
Configuring in the Web-Based Management System (WBM)
Default
Disable
Enable
From: 1
To: 1
Disable
Enable
None
Unblock
Broadcast
Multicast
Bcast+Mcast
Enable
Disable
1 ... 60
Default
1 ... 10
Disable
Enable
Normal
Broadcast
Multicast
Bcast+Mcast
Enable
Disable
1 ... 60
Description
Select "Switch OFF" in the selection box to disable
the "Traffic Monitor" function globally.
Select "Switch ON" in the selection box to enable
the "Traffic Monitor" function globally.
Select a port or port range in the selection box that
you want to configure.
Select a port or port range in the selection box that
you want to configure.
Select "Switch OFF" in the selection box if you want
to disable the "Traffic Monitor" function for the port
or port range.
Select "Switch ON" in the selection box if you want
to enable the "Traffic Monitor" function for the port
or port range.
Select "None" in the selection box if you do not
want to cancel port blocking.
Select "Unblock" in the selection box if you want to
cancel port blocking.
Select "Broadcast" in the selection box, if you want
to monitor this as the packet type.
Select "Multicast" in the selection box, if you want
to monitor this as the packet type.
Select "Bcast+Mcast" in the selection box, if you
want to monitor both as the packet types.
In the input field, enter the packet rate that you want
to monitor.
Select "Switch ON" in the selection box if you want
to enable the "Recover" function in the "Traffic
Monitor" for the port or port range.
Select "Switch OFF" in the selection box if you want
to disable the "Recovery" function in the "Traffic
Monitor" for the port or port range.
Enter a value in the input field for the "Recovery
Time" for the "Traffic Monitor" function.
Description
This column displays the port numbers.
This column displays the status of the specific port.
This column displays the status of the operational
state.
This column displays the type of data packet.
This column displays the selected packet rate.
This column displays the status of the selection
Recover function.
This column displays the selected Recovery time.
241