Table 96: Wbm "802.1X" Page - "Global Settings" Tab - WAGO 852-1305 Manual

WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Table 96: WBM "802.1x" Page – "Global Settings" Tab
Global Settings
Parameters
State
Authentication Method
Guest VLAN
Primary
Radius
Server
Manual
1.1.0
Configuring in the Web-Based Management System (WBM)
Default
Disable
Enable
Local
Radius
IP:
UDP Port:
Shared Key:
Description
Select "Disable" in the selection box to disable
802.1x authentication on the switch.
Select "Enable" in the selection box to enable 802.1x
authentication on the switch.
Note
802.1x Authentication
You must first enable 802.1x
authentication on the switch before
you can configure this function for
individual ports.
Select "Local" in the selection box to use the
"Guest" and "User" user groups from the user
account database on the switch for authentication.
However, the number of node that can exist at the
same time is limited.
Select "Radius" in the selection box to enable the
security protocol that uses an external server for user
authentication in contrast to the internal user
database in devices with limited storage.
In general, "Radius" allows validation of an
unlimited number of users from a central location.
This field is used to configure the VLAN ID.
If you select "Radius" for the authentication method,
the primary RADIUS server is used for all
authentication requests.
In the input field, enter the IP address of the external
RADIUS server in decimal-point notation.
Enter the UDP port in the input field.
Enter a password (up to 32 alphanumeric characters)
in the input field to use as the common key for the
connection between the external RADIUS server and
the switch.
This key may not be sent over the network. The key
must be identical on the external RADIUS server
and the switch.
223