Table of Contents
Advertisement
6
MELSECNET/H UTILITY
6.7
Target Settings Tab
Logical station numbers are set on this tab.
Logical station numbers are used when the target station is a multiple CPU system to
access the programmable controller other than control CPU in the target station.
Note that the logical station number setting is not required for the following access.
(1) Precaution for the Target settings tab
(2) The Target settings tab
Online operation
Parameter settings
Item
Target module
Logical Sta. No.
Network No.
Sta. No.
Target CPU
Set
button
6
- 39
6.7 Target Settings Tab
Page 6-41, "6.7 (4) Access that does not require a logical station No. setting"
Select a programmable controller CPU for the "Target module".
Table 6.33 Description of the Target settings tab
Target settings
Select the module to be configured.
(Default: "Slot 1")
Specify the logical station No. of the module selected in "Target module".
(Default: 65, Setting range: 65 to 239)
The logical station No. is logical numbers to be set in "Sta. No." in Device monitoring utility and
MELSEC data link function (MELSECNET data link function).
Set the network No. of the CC-Link IE Controller Network module and MELSECNET/H module
controlled by the multiple CPU system.
(Default: 1, Setting range: 1 to 239)
Set the station No. of the CC-Link IE Controller Network module and MELSECNET/H module
controlled by the multiple CPU system.
(Default: 1, Setting range: 1 to 120)
Set the CPU (CPU No. used in the multiple CPU system) to be accessed.
(Default: 1, Setting range: 1 to 4)
Registers the settings (Logical Sta. No., Network No., Sta. No., and Target CPU) to the Target list.
Q12DCCPU-V
Figure 6.25 Target settings tab
Description
Q06CCPU-V
Q06CCPU-V-B
(To the next page)
Advertisement
Table of Contents
