Table of Contents
Advertisement
9
PROGRAMMING USING BUS INTERFACE
FUNCTIONS
9.3
Programming Procedure
This section provides the procedure for programming using the bus interface functions or
MELSEC data link functions.
Complete the settings of a C Controller module.
Install Workbench or Tornado into the development
environment (personal computer).
Check that the image file in the system memory of the
development environment (personal computer)
matches with that of the C Controller module.
Activate Workbench or Tornado on the development
environment (personal computer), and create a
project of the user program.
Complete the settings for bus interface functions and
MELSEC data link functions.
Create an user program using the bus interface
functions and MELSEC data link functions.
Debug the user program with Workbench or Tornado.
No
Is debugging completed?
Write the user program created into the standard RAM,
standard ROM, or CompactFlash card.
Create the script file "STARTUP.CMD", and write it into
the standard RAM, standard ROM, or CompactFlash
card.
For the Q12DCCPU-V, back up the file in the standard
RAM since the file may be cleared when the battery life
has expired.
Start
Yes
End
Figure 9.2 Programming procedure
Q12DCCPU-V
Q06CCPU-V
C Controller Module User's Manual
(Hardware Design, Function Explanation)
Manual for Workbench or Tornado
Page 9-31, Section 9.7
Page 9-9, Section 9.4
Page 9-9, Section 9.4
Page 9-23, Section 9.5,
Page 9-26, Section 9.6,
Page 10-5, Section 10.5,
Page 10-9, Section 10.6
Page 9-31, Section 9.7
Error codes of bus interface
functions and MELSEC
data link functions
HELP for each function
Page 9-46, Section 9.8
Page 9-51, Section 9.9
Page 9-46, Section 9.8,
Page 12-1, CHAPTER 12
9.3 Programming Procedure
9
Q06CCPU-V-B
10
11
12
13
A
I
9
- 8
Advertisement
Table of Contents
