Table of Contents
Advertisement
3
COMMON UTILITY OPERATIONS
3.5
Setting Connection Target
Connect an development environment (personal computer) and the C Controller module.
(1) Operating procedure
(Completed)
1
Select "192.168.3.3 (Default)" in "Target module".
When the IP address of the C Controller module has been
changed, enter the IP address or host name currently set.
2
Select the "Write authority" check box and enter the
following.
User name: target
Password: password
When the account of the C Controller module has been
changed, enter the user name and password currently set
to the account.
3
Check the connectivity with the C Controller by clicking the
Test
button.
Note that in startup or after reset of the C Controller
module, the timing to click the button differs according to
the script file "STARTUP.CMD" usage.
The timing to click the
When executing "STARTUP.CMD":
After the RUN LED finished flashing
When not executing "STARTUP.CMD":
15 seconds after the startup or reset of the module.
4
Clicking the
Connect
with the C Controller module, and the screen shown on the
left appears.
Click the
Yes
button when reading out parameters from
the C Controller module.
3.5 Setting Connection Target
Q12DCCPU-V
Q06CCPU-V
Test
button;
button establishes a connection
1
Q06CCPU-V-B
2
3
4
5
6
7
8
3
- 5
Advertisement
Table of Contents
