Mitsubishi Electric Q12DCCPU-V User Manual page 170

6
MELSECNET/H UTILITY
(3) Routing parameter settings screen
Item
Transfer target network No.
Relay network No.
Relay station No.
6
- 31 6.6 Parameter Settings Tab
Transfer destination, relay network No., and relay station No. are set on this screen.
POINT
1. The MELSECNET/H module controlled by the C Controller module cannot be
used a relay station which operates as a bridge.
For a relay station, use the MELSECNET/H module that is controlled by a
programmable controller CPU which is capable of configuring multiple
network systems.
2. Routing parameters are common in the following channels.
Different parameters cannot be set for each channel No.
• MELSECNET/H (Channel No.51 to 54)
• CC-Link IE Controller Network (Channel No.151 to 154)
Figure 6.20 Routing parameter settings screen
Table 6.24 Description of the Routing parameter settings screen
Set the transfer target network No.
(Default: "(blank)", Setting range: 1 to 239)
Set the relay network No.
(Default: "(blank)", Setting range: 1 to 239)
Set the relay station No.
(Default: "(blank)", Setting range: 1 to 120)
Description
(To the next page)