Table of Contents
Advertisement
9
PROGRAMMING USING BUS INTERFACE
FUNCTIONS
Remark
(4) Shell display setting
To display output information (such as printf) from each task of the C Controller
module, the following setting is required.
Without the following setting, only the output information on the Shell task is
displayed.
Remark
For other debugging methods, refer to the manual for Tornado.
1) Start Tornado.
2) Select [Tools] [Target Server] [Configure] to open the "Configure Target
Servers" dialog box.
3) Select "Console and Redirection" in the "Target Server Properties" pull-down
menu.
4) Check the "Redirect Target IO" checkbox.
OK
5) Click the
button.
4)
For other debugging methods, refer to the manual for Tornado.
Figure 9.10 Shell display setting
9.7 Precautions for Program Debugging
9.7.2 For the Q06CCPU-V(-B)
9
10
11
12
13
3)
A
I
9
- 42
Advertisement
Table of Contents
