Table of Contents
Advertisement
7
CC IE CONTROL UTILITY
Table 7.21 Description of Equal assignment screen (for LX/LY settings (1) or LX/LY settings (2))
Item
Identical point assignment
OK
button
Cancel
button
Equal assignment
M station to L station equal
assignment
Start station
End station
Start No.
Total points assigned
L station to M station equal
assignment
(b) When "LX/LY settings (1)" or "LX/LY settings (2)" is set for "Switch screens" in
"Network range assignment"
Figure 7.28 Equal assignment screen (for LX/LY settings (1))
Equally assigns the entered points to link devices of each station. (In increments of 16 points)
Note that no points are assigned to any I/O master station. (
(Default: "(Blank)", Setting range: 16 or greater)
Executes equal assignment according to the settings, and closes the "Equal assignment" screen.
Closes the "Equal assignment" screen without executing equal assignment.
Equally divides the entered points and assigns them to link devices of each station.
Set data for equal assignment of LY (1) or LY (2).
Specify the start station.
(Default: "(Blank)", Setting range: 1 to ("Total stations" setting))
"Total stations" is set on the "Network range assignment" screen. (
(5))
Specify the end station.
(Default: "(Blank)", Setting range: ("Start station" setting) to ("Total stations" setting))
"Total stations" is set on the "Network range assignment" screen. (
(5))
Set the start No. of the link device.
(Default: "(Blank)", Setting range:
Set the total link device points.
(Default: "(Blank)", Setting range:
Set data for equal assignment of LX (1) or LX (2).
Set respective items as in "M station to L station equal assignment".
Description
Page 7-29, Section 7.5 (5))
Page 7-30, Section 7.5 (5) (a))
Page 7-30, Section 7.5 (5) (a))
7.5 Parameter Settings Tab
Page 7-29, Section 7.5
Page 7-29, Section 7.5
7
- 32
1
2
3
4
5
6
7
8
Advertisement
Table of Contents
