Mitsubishi Electric Q12DCCPU-V User Manual page 208

7
CC IE CONTROL UTILITY
(3) Routing parameter settings screen
Item
Transfer target network No.
Relay network No.
Relay station No.
7
- 25 7.5 Parameter Settings Tab
The transfer target network, relay network, and relay station can be specified on this
screen.
POINT
1. The CC-Link IE Controller Network module controlled by a C Controller
module cannot be a relay station that is supposed to act as a bridge.
As a relay station, use a CC-Link IE Controller Network module controlled by
a programmable controller CPU with which multiple network systems can be
constructed.
2. Common routing parameters must be used for the following channels.
Different settings for each channel No. are not allowed.
• CC-Link IE Controller Network (Channel No.151 to 154)
• MELSECNET/H (Channel No.51 to 54)
Table 7.13 Description of Routing parameter settings screen
Set a transfer target network No.
(Default: "(Blank)", Setting range: 1 to 239)
Set a relay network No.
(Default: "(Blank)", Setting range: 1 to 239)
Set a relay station No.
(Default: "(Blank)", Setting range: 1 to 120)
Figure 7.24 Routing parameter settings screen
Description
(To the next page)