Table of Contents
Advertisement
3
COMMON UTILITY OPERATIONS
3.4
Specifying CPU Type
Select the C Controller module for parameter setting and monitoring in utility other than
Device monitoring utility.
CPU type
OK
Remark
3
- 4
3.4 Specifying CPU Type
Table 3.2 Description of the Specify CPU type screen
Item
Specifies a C Controller module to which parameters are set or to be monitored.
(Default: "Q12DCCPU-V")
The specified CPU type is fixed and this screen will not be displayed on and after next
utility operation.
CPU type fixed
To set back to the default (CPU type not fixed), select [Specify CPU type] in the system
menu to open this screen and deselect the check box.
(Default: Deselected (CPU type not fixed))
Sets the selected C Controller module as the CPU type and closes this screen.
button
Closes this screen without changing the CPU type.
Cancel
button
1. Changing CPU type
Select [Specify CPU type] from the system menu and change the CPU type.
(
Page 4-46, Section 4.12, Page 5-21, Section 5.8, Page 6-42, Section
6.8, Page 7-37, Section 7.7)
2. When writing parameters or performing communication processing such as
monitoring to any other CPU type, change the CPU type on this screen in
advance.
For the following communication processing, CPU type change is available in
the processing.
• Connection target settings
• Parameter read
Figure 3.4 Specify CPU type screen
Description
Q12DCCPU-V
Q06CCPU-V
Q06CCPU-V-B
Advertisement
Table of Contents
