Table of Contents
Advertisement
8
DEVICE MONITORING UTILITY
8.2
Batch Monitoring
Only one specified device can be monitored.
(1) Precautions for batch monitoring
8
- 2
8.2 Batch Monitoring
(a) When a utility communication error has occurred
When a utility communication error has occurred during connection, set the
connection target again in the Connection settings so that the communication can
be restarted.
(b) CC-Link module monitoring
When monitoring has been performed to the CC-Link module (specified as own
station) where the block data assurance per station is enabled, cyclic data are will
be automatically refreshed.
However, data are automatically refreshed only when monitoring has been
performed within the range set in "Station information settings" for the master
station.
The range set in "Station information settings" can be confirmed by "Slave station
offset, size information" (buffer memory address: 3E0
module.
For details of the block data assurance per station, refer to the C Controller
Module User's Manual (Hardware Design, Function Explanation).
Note also that the write (send) area of the link refresh devices (the buffer memory)
will not be refreshed when monitoring has been performed.
Q12DCCPU-V
Q06CCPU-V
to 5DF
) of the CC-Link
H
H
Q06CCPU-V-B
Advertisement
Table of Contents
