Table of Contents
Advertisement
7
CC IE CONTROL UTILITY
7.4
Online Operation Tab
The CC-Link IE Controller Network parameters can be read, written, or verified from this
tab.
(1) Precautions for the Online operation tab
(2) Online operation tab
Online operation
Module information
Item
Target drive
(a) When a utility communication error has occurred
When a utility communication error has occurred during connection, set the
connection target again in the Connection settings so that the communication can
be restarted.
(b) During reset
Communications are not available while the C Controller module is being reset.
Start communications after the reset is complete.
(c) The drive to which parameters are written
When writing parameters from each of the utilities to the following C Controller
module, write them to the same drive.
• Q12DCCPU-V whose serial No. (first five digits) is "12042" or later
If the parameters are written to different drives, those of the drive, which include C
Controller setting parameters, will take effect.
Table 7.11 Description of Online operation tab
Parameter settings
Set a target drive for reading, writing, or verifying parameters.
This setting is not available for the Q06CCPU-V(-B).
(Default: Parameter boot drive)
* 1 For the drives to which parameters can be written (user memory), refer to the C Controller Module
User's Manual (Hardware Design, Function Explanation).
Q12DCCPU-V
Figure 7.20 Online operation tab
Target settings
Description
7.4 Online Operation Tab
Q06CCPU-V
Q06CCPU-V-B
*1
(To the next page)
7
- 20
1
2
3
4
5
6
7
8
Advertisement
Table of Contents
