Table of Contents
Advertisement
5
CC-LINK UTILITY
5.5
Parameter Settings Tab
Set the CC-Link module parameter in the Parameter settings tab.
(1) Parameter settings tab
Other station monitoring
Module information
Item
Number of modules
Target module
Start I/O No.
Channel No.
Default
button
Check
button
Figure 5.8 Parameter settings tab
Table 5.12 Description of Parameter settings tab
Parameter settings
Online operation
Set the number of CC-Link modules that are to be controlled by the C Controller module.
Selecting "(Blank)" means no setting (Setting cleared).
(Default: "(Blank)")
Select a module to configure. (Default: 1)
The numbers for this item will be automatically rearranged in ascending order of start I/O numbers
when saving the parameter setting file or when switching the tab.
Set a start I/O No. of a CC-Link IE Controller Network module.
(Setting range: 0 to FE0
(The set value must be unique, and not duplicated with the one for
H
another CC-Link IE Controller Network module.))
Set a channel No. of a CC-Link IE Controller Network module.
The set value is used to open the channel from Device monitoring utility or a user program
(MELSEC data link functions).
For the Q06CCPU-V-B, this setting is not available.
Channel No. must be unique, and not duplicated with the one for another CC-Link IE Controller
Network module.
Sets the parameters for Operation settings and Station information settings back to default.
Checks for any setting error.
Q12DCCPU-V
Q06CCPU-V
Target settings
Description
5.5 Parameter Settings Tab
1
Q06CCPU-V-B
2
3
4
5
Test
6
7
(To the next page)
8
5
- 11
Advertisement
Table of Contents
