Table of Contents
Advertisement
6
MELSECNET/H UTILITY
Table 6.30 Description of the Equal assignment screen (for LX/LY settings (1) and (2))
Item
Identical point assignment
OK
button
Cancel
button
Equal assignment
M station to L station equal
assignment
Start station
End station
Start No.
Total points assigned
L station to M station equal
assignment
(b) When "LX/LY settings (1)" or "LX/LY settings (2)" is set for "Switch screens" in the
Parameter settings tab.
Figure 6.23 Equal assignment screen (for LX/LY settings (1))
Equally assigns entered points to the link devices of each station. (In increments of 16)
Note that the points will not be assigned to the station, which is set as the I/O master station. (
Page 6-27, Section 6.6 (2))
(Default "(Blank)", Setting range: 16 or more)
Validates the equal assignment setting according to entered values and closes the Equal
assignment screen.
Discard the settings and closes the Equal assignment screen.
Equally divides the entered points and assigns them to the link devices of each station.
Set the method for equal assignment to LY(1) or LY(2).
Set the first of the stations to which equal assignment will be performed.
(Default "(Blank)", Setting range: 1 to (Value set in "Total stations"))
The value for "Total stations" can be set in the "Network range assignment" in the Parameter
settings tab. (
Page 6-27, Section 6.6 (2))
Set the last of the stations to which equal assignment will be performed.
(Default "(Blank)", Setting range: (Value set in "Start station" to "Total stations"))
The value for "Total stations" can be set in the "Network range assignment" in the Parameter
settings tab. (
Page 6-27, Section 6.6 (2))
Set the start No. of the link device to be equally assigned.
(Default "(Blank)", Setting range:
Set the total points of the link devices to be equally assigned.
(Default "(Blank)", Setting range:
Set the method for equal assignment to LX(1) or LX(2).
Setting method is the same as for "M station to L station equal assignment" described above.
Description
Page 6-30, Section 6.6 (2) (a))
Page 6-30, Section 6.6 (2) (a))
6.6 Parameter Settings Tab
1
2
3
4
5
6
7
8
6
- 36
Advertisement
Table of Contents
