Table of Contents
Advertisement
3
COMMON UTILITY OPERATIONS
Remark
(2) Utilizing existing parameter settings in the parameter setting file
Multiple modules can be used under the same parameter setting by loading a existing
parameter file into multiple development environments (personal computers).
Remark
1. The name of the parameter setting file currently used is displayed on the
status bar in utilities other than Device monitoring utility.
2. The following table lists the extensions for parameter setting files.
Table 3.8 Extensions for parameter setting file
Utility
C Controller setting utility
CC-Link utility
MELSECNET/H utility
CC IE Control utility
3. The standard folder, where utilities other than Device monitoring utility save
parameter setting files, is "C:\MELSEC\CCPU\Param". (When SW3PVC-
CCPU has been installed in "C:\MELSEC")
4. Double-clicking any saved parameter setting file (*.cst, *.ccl, *.mnh, or *.mng)
starts the corresponding utility with the saved parameter setting loaded.
5. When a parameter setting file is loaded, utility will be in the following status.
Item
Changed back to the one set when the parameter setting file was
CPU type
saved.
Disconnected and monitoring is stopped.
Connection
To restart monitoring, click the
again in Connection settings.
Parameter settings can be utilized without a parameter setting file with the
following procedure.
1. Set parameters in utility other than Device monitoring utility.
2. Open the Connection settings screen and connect to the module where the
parameters are written.
3. Write the parameters to the C Controller module by clicking the
in the <<Online operation>> tab of each utility.
4. By repeating steps 2 and 3, the same parameter setting can be set to multiple
modules.
Extension for parameter setting file
Table 3.9 Utility status
Status
Start monitoring
3.8 Parameter Setting File
cst
ccl
mnh
mng
button or set data
Write
button
3
- 15
1
2
3
4
5
6
7
8
Advertisement
Table of Contents
