Table of Contents
Advertisement
13
EVENT NUMBER LIST
CHAPTER 13 EVENT NUMBER LIST
When an event such as an error occurs in the C Controller system, information required to
correct errors such as an event No. is displayed on the Event history tab. When an event
has occurred, check the event No. in the following procedure and take corrective actions.
13
- 1
POINT
When more than one event occur, take corrective actions for each event in
chronological order.
1) Open the "Detailed event information" screen by double-clicking on a event to
correct on the history screen of C Controller setting utility. (
Section 4.3 (3))
2) When "Application" is shown in the "Event type" field, it indicates that the event
was registered by the user program (QBF_RegistEventLog function). Take
corrective actions determined by user.
3) The following "Event type" indicate that the event has occurred in the C
Controller system.
• System (Info.)
• System (Warning)
• System (Err.)
Check "source" and "event No." on the Detailed event information screen, and
take corrective actions referring to the following table.
Source
MQbfDrv
MXwdkDrv
MUtlIfQbf
MUtlIfMd
MUtlIfCom
MMain
MFDrv
MCfDrv
MEtherDrv
Figure 13.1 Detailed event information screen
Table 13.1 Source list
Data type
Bus interface driver (bus part) related
Bus interface driver (system part) related
Utility communication interface (bus interface part) related
Utility communication interface (MELSEC communication
part) related
Utility communication interface (common part) related
C Controller module main part related
Flash ROM and standard RAM related
CompactFlash card related
Ethernet related
Q12DCCPU-V
Q06CCPU-V
Page 4-6,
Q06CCPU-V-B
Reference
page
Page 13-2
Page 13-3
Page 13-3
Page 13-4
Page 13-4
Page 13-5
Page 13-5
Page 13-7
Page 13-8
Advertisement
Table of Contents
