Table of Contents
Advertisement
6
MELSECNET/H UTILITY
(5) Equal assignment screen
Item
Identical point assignment
OK
button
Cancel
button
Equal assignment
LB equal assignment
Start station
End station
Start No.
Total points assigned
LW equal assignment
Low speed LB equal assignment
Low speed LW equal assignment
6
- 35
6.6 Parameter Settings Tab
The link device points of all stations can be equally assigned on this screen.
For the start and end stations, set values within the number of the stations for equal
assignment target, which can be calculated in the following expression:
(Total link stations
-
(a) When "LB/LW settings" is set for "Switch screens" in the Parameter settings tab.
Figure 6.22 Equal assignment screen (for LB/LW settings)
Table 6.29 Description of the Equal assignment screen (for LB/LW settings)
Equally assigns entered points to the link devices of each station. (In increments of 16)
(Default "(Blank)", Setting range: 16 or more)
Validates the equal assignment setting according to entered values and closes the Equal
assignment screen.
Discard the settings and closes the Equal assignment screen.
Equally divides the entered points and assigns them to the link devices of each station.
Set the method for equal assignment to LB
Set the first of the stations to which equal assignment will be performed.
(Default "(Blank)", Setting range: 1 to (Value set in "Total stations"))
The value for "Total stations" can be set in the "Network range assignment" in the Parameter
settings tab. (
Set the last of the stations to which equal assignment will be performed.
(Default "(Blank)", Setting range: (Value set in "Start station" to "Total stations"))
The value for "Total stations" can be set on the "Network range assignment" in the Parameter
settings tab. (
Set the start No. of the link device to be equally assigned.
(Default "(Blank)", Setting range:
Set the total points of the link devices to be equally assigned.
(Default "(Blank)", Setting range:
Set the method for equal assignment to LW.
Set each item the same as for "LB equal assignment"
Set the method for equal assignment to low-speed LB.
Setting method is the same as for "LB equal assignment" described above.
Set the method for equal assignment to low-speed LW.
Setting method is the same as for "LB equal assignment" described above.
(Start station No.
1))
-
Description
Page 6-27, Section 6.6 (2))
Page 6-27, Section 6.6 (2))
Page 6-30, Section 6.6 (2) (a))
Page 6-30, Section 6.6 (2) (a))
Advertisement
Table of Contents
