Table of Contents
Advertisement
3
COMMON UTILITY OPERATIONS
Remark
1. Offline operation
Parameters can be written to each utility offline.
When writing parameters, a connection must be established with the C
Controller module.
2. Changing connection target
To connect with other target, open the "Connection settings" screen with the
following operations and change the IP address or host name.
• For other than Device monitoring utility
Connection settings
Click the
• For Device monitoring utility
Select [Setting] [Connection settings] from the menu bar.
3. The connection target when other utility is started from the system menu.
Connection is established with the same C Controller module.
4. How to check the connection target and user name
Check on the title bar and status bar. (
5. When the C Controller module specified in the CPU type on utility (other than
Device monitoring utility) and the connection target C Controller module are
not the same type.
Change the setting to the C Controller module that is to be connected as the
CPU type, and then set it in Connection settings.
For changing the CPU type, refer to the following.
Page 3-4, "3.4 Specifying CPU Type"
button at the bottom left of the screen.
Page 3-16, Section 3.9)
3.5 Setting Connection Target
1
2
3
4
5
6
7
8
3
- 9
Advertisement
Table of Contents
