7
PARAMETER SETTINGS
This section describes the parameter settings required to perform CC-Link IE Field Network Basic and general-purpose
Ethernet communication with FX5-ENET.
For details on each operation of GX Works3, refer to GX Works3 Operating Manual.
7.1
Procedure for Setting Parameters
1.
Add the "Information Module (FX5-ENET)" in GX Works3.
[Navigation window] [Parameter] [Module Information] Right-click [Add New Module]
2.
Select the "FX5-ENET".
[Navigation window] [Parameter] [Module Information] [FX5-ENET]
3.
Set the parameter.
4.
Write the parameter settings to the CPU module.
[Online] [Write to PLC]
5.
The settings are reflected by resetting the CPU module or powering off and on the system.
*1 FX5-ENET can be added to GX Works3 also from the module configuration diagram.
Writing parameters
The FX5-ENET parameters are written to the CPU module.
For writing parameters to the CPU module, refer to the following.
GX Works3 Operating Manual
7.2
Required Setting
Set the operation mode of the FX5-ENET.
Mode
Set the operation mode of the FX5-ENET.
Item
Communication Mode
In the hardware test mode, other parameters cannot be set.
7 PARAMETER SETTINGS
68
7.1 Procedure for Setting Parameters
Description
Set the operation mode of the FX5-ENET.
• Online: Normal operation mode
• Hardware Test: Mode in which the module performs a self-diagnostics
test. Select this mode when checking the operation of the module due to
an error or similar problem. ( Page 106 Hardware Test)
* 1
Setting range
• Online
• Hardware Test
(Default: Online)