Chapter 5 Parameter Settings; Setting Parameters; Required Settings; Station Type - Mitsubishi Electric MELSEC iQ-F FX5 Series User Manual

5
PARAMETER SETTINGS
This chapter describes the parameter settings required for communications between the Motion module and other stations.
5.1

Setting Parameters

1.
Add the Motion module in the engineering tool.
Navigation window  "Parameter"  "Module Information"  Right-click  [Add New Module]
2.
The required settings, basic settings, and application settings are included in the parameter settings. Select one of the
settings from the tree on the following window.
Navigation window  "Parameter"  "Module Information"  Target Module  "Module Parameter (Network)"
3.
After setting parameters, click the [Apply] button.
4.
Write parameters to the CPU module using the engineering tool.
[Online]  [Write to PLC]
5.
The parameters are reflected by resetting the CPU module or powering off and on the system.
5.2

Required Settings

Set such items as the station type and network number of the Motion module.
Item

Station Type

Network No.
Parameter Setting Method
Station No./IP Address Setting
Station Type
Set the station type of the Motion module.
Item
Station Type
5 PARAMETER SETTINGS
98
5.1 Setting Parameters
Description
Set the station type of the Motion module.
Set the network number of the Motion module.
Set "Basic Settings" and "Application Settings" items using the engineering tool or in
program.
Set the station number or IP address of the Motion module.
Description
Uses the Motion module as the master station.
Only one master station can be set in a network.
Reference
Page 98 Station Type
Page 99 Network No.
Page 99 Parameter
Setting Method
Page 99 Station No./IP
Address Setting
Setting range
