Provisioning Mgcp / Megaco Parameters; Figure 3-2: Mediant 2000 Mgcp/Megaco Quick Setup Screen - AudioCodes Mediant 2000 Installation Manual

Note:
3.2

Provisioning MGCP / MEGACO Parameters

After completing steps
Setup' screen is accessed, as shown in

Figure 3-2: Mediant 2000 MGCP/MEGACO Quick Setup Screen

To provision basic MGCP / MEGACO parameters take these 16 steps:
1.
In the 'Default Gateway Address' field, enter the IP address for the default gateway. If you do
not know the IP address for the default gateway, contact your network administrator. Enter
0.0.0.0 if a default gateway isn't used.
2. If your network features a DNS server, in the fields 'DNS Primary Server IP' and 'DNS
Secondary Server IP', enter the IP address of the primary and secondary DNS servers
(clarify with your network administrator). Note that the DNS server option is supported for
MEGACO but not for MGCP.
Mediant 2000
The following Provisioning Sections from here up to and including Section
on page 20 apply individually to MGCP/MEGACO, H.323, or SIP.
MGCP/MEGACO Provisioning continues with Section
H.323 Provisioning continues with Section
SIP Provisioning continues with Section
1 to 10 (pages 14
Figure
3.3 on page 18.
3.4 on page 20.
& 15) under Section 3.1, the MGCP / MEGACO 'Quick
3-2.
16
Mediant 2000
3.4
3.2 on page 16.
Document #: LTRT-70102