CHAPTER 23 Digital PSTN
For IP-to-Tel overlap dialing, to send ISDN Setup messages without including the
Sending Complete IE, you must configure the ISDNOutCallsBehavior parameter to
USER SENDING COMPLETE [2].
For more information on the above mentioned parameters, see
ISDN overlap dialing using the Web interface, see
Redirect Number and Calling Name (Display)
The following tables define the device's redirect number and calling name (Display) support for
various ISDN variants according to NT (Network Termination) / TE (Termination Equipment)
interface direction:
NT/TE Interface
NT-to-TE
TE-to-NT
NT/TE Interface
NT-to-TE
TE-to-NT
* When using ETSI DivertingLegInformation2 in a Facility IE (not Redirecting Number IE).
Table 23-3: Calling Name (Display)
DMS-100
NI-2
Yes
Yes
Yes
Yes
Table 23-4: Redirect Number
DMS-100
NI-2
Yes
Yes
Yes
Yes
- 593 -
Mediant 800 Gateway & E-SBC | User's Manual
PSTN
Parameters. To configure
Configuring Trunk
Settings.
4/5ESS
Euro ISDN
Yes
Yes
4/5ESS
Euro ISDN
Yes
Yes
QSIG
Yes
Yes
No
Yes
QSIG
Yes
Yes
Yes*
Yes