Relay Mode For T.30 And V.34 Faxes; V.34 Fax Relay For Sg3 Fax Machines - AudioCodes Mediant 800 User Manual

CHAPTER 15 Media
● Set the 'V.32 Modem Transport Type' parameter to Enable Bypass
[V32ModemTransportType = 2].
● Set the 'V.34 Modem Transport Type' parameter to Enable Bypass
[V34ModemTransportType = 2].
2. Configure the [V34FaxTransportType] parameter to [2] (Bypass).

Relay Mode for T.30 and V.34 Faxes

In this scenario, V.34 fax machines are forced to use their backward compatibility with T.30 faxes
and operate in the slower T.30 mode.
➢
To use T.38 mode for V.34 and T.30 faxes:
1. On the Fax/Modem/CID Settings page, do the following:
● Set the 'Fax Transport Mode' parameter to T.38 Relay (FaxTransportMode = 1).
● Set the 'V.22 Modem Transport Type' parameter to Disable (V22ModemTransportType =
0).
● Set the 'V.23 Modem Transport Type' parameter to Disable (V23ModemTransportType =
0).
● Set the 'V.32 Modem Transport Type' parameter to Disable (V32ModemTransportType =
0).
● Set the 'V.34 Modem Transport Type' parameter to Disable (V34ModemTransportType =
0).
2. Configure the [V34FaxTransportType] parameter to [1] (Relay).
➢
To allow V.34 fax relay over T.38:
■ Set the 'SIP T.38 Version' parameter to Version 3 (SIPT38Version = 3).
➢
To force V.34 fax machines to use their backward compatibility with T.30 faxes and
operate in the slower T.30 mode:
■ Set the 'SIP T.38 Version' parameter to Version 0 (SIPT38Version = 0).
Interworking of T.38 Version 3 is supported only for Gateway calls. For SBC calls, the
device forwards T.38 Version 3 transparently (as is) to the other leg (i.e., no
transcoding).

V.34 Fax Relay for SG3 Fax Machines

Super Group 3 (SG3) is a standard for fax machines that support speeds of up to 33.6 kbps through
V.34 half duplex (HD) modulation. The following procedure describes how to configure V.34 (SG3)
fax relay support based on ITU Specification T.38 version 3.
➢
To enable support for V.34 fax relay (T.38) at SG3 speed:
1. In the IP Profiles table (see
Signaling Method' parameter (IpProfile_IsFaxUsed) set to T.38 Relay.
2. In the Coder Groups table (see
G.729 (or any other supported codec).
3. On the Fax/Modem/CID Settings page, do the following settings:
● 'SIP T.38 Version' to Version 3 (SIPT38Version = 3).
● 'Fax Relay Max Rate' (RelayMaxRate) to 33,600bps (default).
● 'CNG Detector Mode' (CNGDetectorMode) to Disable (default).
Mediant 800 Gateway & E-SBC | User's Manual
Configuring IP Profiles), configure an IP Profile with the 'Fax
Configuring Coder Groups) set the coder used by the device to
- 169 -