When Gt Designer Is Used - Mitsubishi Electric F930GOT-BWD Operation Manual

Graphic Operation Terminal GOT-F900
9.6.2

When GT Designer is used

1) Completion flag
When a screen is created using the GT Designer, the system information (described in
Paragraph 9.6.2) write device D¡+4 b2 turns ON as the completion flag.
System information
• D¡+4 b2
"¡" indicates the head write device No.
Operation
• When "Project Unit" in "Auxiliary Setting" in "Common Setting" in the screen creation
software is set so that the key window is open, and the ENT key is pressed on the ten-key
window, the flag turns ON.
• While the touch key code is set to "000D", the flag turns ON when the touch key is pressed.
2) User ID
The user ID can be assigned to each "Numerical Input" and "Ascii Input" using the screen
creation software.
The programmer can set arbitrarily the user ID within the range of 1 to 165535. The user ID
is written to the following device in the PLC.
System information
• D¡+3
"¡" indicates the head write device No.
By checking the current value of D¡+3, the user can know which "Numerical Input/Ascii
Input" has been changed.
Screen mode 9
9-17