Mitsubishi Electric F930GOT-BWD Operation Manual page 50

Graphic Operation Terminal GOT-F900
[ SERIAL PORT ]
[ SERIAL PORT ]
SPEED:
DATA BIT:
STOP BIT:
PARITY:
HANDSHAKING:
PRINTER:
[ OPENNING SCREEN ]
[ OPENNING SCREEN ]
DISPLAY TIME
5 6 7
0 1 2
END
9600 bps
7 bit
1 bit
Even
XON/XOFF
DON'T USE
END
4 SEC.
8 9 - CLR
3 4 ENT
• Set the serial communication parameters for the
printer used to print out alarm messages and sampling
data. (Initial: Left screen)
• Make sure to set "PRINTER" to "USE" when a printer
is connected.
When it is set to "USE", the two-port interface
function is not available.
• When "LINK PORT (RS232C)" is selected on the PLC
TYPE screen, a printer cannot be connected.
• Set the duration in units of seconds in which the
OPENING SCREEN indicating the model name, the
version, etc. is displayed immediately after the power
is turned on. (Initial: 4sec)
• When the touch key "DISPLAY TIME" is pressed, the
time can be set using the ten-key pad displayed at the
bottom of the screen.
• Enter the desired display time using the ten-key pad
displayed at the bottom of the screen, then press the
ENT key to register the input time.
* If "DISPLAY TIME" is set to "0", the screen mode is
selected immediately after the power is turned on
and a user screen is displayed.
It is recommended to set 1 second or more for the
FX Series and 4 seconds or more for the A Series.
Start up 7
7-6