Sampling Mode; Outline Of Sampling Mode - Mitsubishi Electric F930GOT-BWD Operation Manual

Graphic Operation Terminal GOT-F900
11.

Sampling Mode

This section describes the sampling mode in which the contents of continually changing data
registers are acquired at a constant time interval (in a constant cycle) or, in the ON/OFF
condition (trigger) of bit devices.
The acquired data can be displayed in graph or list format.
The acquired data can be printed in the 'Other mode' of the GOT or using the user screen
creation software. The sampling mode can be used to manage data on the operation rate of
machines and the production status.
F930GOT has no sampling mode.
11.1

Outline of sampling mode

The contents of the specified 4 data registers (16 bits) are acquired in a constant cycle or by a
trigger condition. The data in up to 2,000 registers can be acquired in a constant cycle, by the
trigger condition.
u u u u Basic operation
SELECT MODE
screen
Paragraph 7.3
[ SAMPLING MODE ]
SET CONDITION
DISPLAY LIST
DISPLAY GRAPH
CLEAR DATA
SAMPLING MODE
Select "SAMPLING
MODE".
• When "SAMPLING MODE" is selected, the screen
END
shown on the left is displayed. On this screen, the
a)
b) sampling condition can be set, the results displayed,
c)
and the acquired data cleared.
d)
a) SET CONDITION (Paragraph 11.2)
Data registers to be sampled, the sampling timing
(trigger or constant cycle), the sampling start and end
times can be set.
b) DISPLAY LIST (Paragraph 11.3)
The sampling time (hour, minute and second) and
sampling result are displayed in the form of list.
c) DISPLAY GRAPH (Paragraph 11.3)
The sampling result is displayed in the form of trend
graph.
d) CLEAR DATA (Paragraph 11.4)
All of the data acquired by sampling is cleared.
SAMPLING MODE
screen
The screen shown
below is displayed.
Sampling Mode 11
11-1