Changeover To System Screen; Display Example Of System Screen - Mitsubishi Electric F930GOT-BWD Operation Manual

Graphic Operation Terminal GOT-F900
21.5

Changeover to system screen

Function screens built in the GOT such as HPP MODE screen, SAMPLING MODE screen,
ALARM MODE screen and the OTHER MODE screen can be displayed as user screens.
21.5.1

Display example of system screen

This paragraph describes the method to display a system screen as a user screen (that is,
display a system screen in screen mode) and a caution on this method.
• A system screen can be displayed by specifying a corresponding screen No. shown in the
next page. In this case, the following setting is required so that the previous user screen can
be displayed after the system screen.
1) When a system screen is displayed as the base screen (from the PLC)
Screen No. n
Screen No. 1001
[ DEVICE MONITOR screen ]
[ DEVICE MONITOR ]
DEVICE ON
SET
COMMENT
Return to the user screen No. + "END" key
• A sequence program to return to a user screen can be executed at any time while a system
screen is displayed.
2) When a system screen is displayed using a touch key
• Specify a desired screen No. within the range of Nos. 1001 to 1030 in the same way as
specification of a user screen.
• When the END key provided at the upper right corner of the system screen is pressed,
the previous user screen is automatically displayed again. (That is, the setting to return
to the previous screen is not required.)
END
OFF
DEC/HEX
Changeover of Display Screen (GT Designer) 21
• When the sequence program shown below is executed
while screen No. n is displayed, screen No. 1001
(DEVICE MONITOR screen) is displayed.
- Word device to change over the base screen of the
GOT: D0
- Sequence program
MOV
• To return to the previously displayed user screen from
a system screen, execute a program which specifies
the screen to be returned and press the END key
provided at the upper right corner of the system
screen. Then, the previous user screen is displayed
again.
MOV K¡¡¡
Screen No. 1001 is
K1001 D0
specified.
D0
Word device for changeover
No. of a screen to be displayed
next (user screen No.).
21-7