Mitsubishi Electric F930GOT-BWD Operation Manual page 114

Graphic Operation Terminal GOT-F900
Insertion operation
c)
Deletion operation
d)
n n n n Important point
1) While an instruction, device symbol or device No. is entered, the input can be canceled by
pressing the CLR key if the GO key has not been pressed.
An instruction determined by pressing of the GO key in the write or insertion operation can
be changed (overwritten) by write of a program.
2) To create a new program, perform the write operation.
3) To enter an application instruction, enter the FNC No.
4) While the PLC is running, only the read operation can be performed.
When performing write, insertion or deletion of a program, stop the PLC.
5) Programs can be edited only while a RAM or EEPROM (whose write-protect switch is set to
OFF) is used in the PLC.
MORE Instruction
Change
For an instruction without
the key
device symbol and device
indication.
No., enter the instruction only.
GO
Delete one
instruction in the
cursor position.
Device Device
GO
symbol No.
Insert one line
above the
cursor
position.
HPP Mode 10
10-6