Application Of Screen Changeover; Application Example 1 - Mitsubishi Electric F930GOT-BWD Operation Manual

Graphic Operation Terminal GOT-F900
21.6

Application of screen changeover

This paragraph describes application examples of screen changeover.
21.6.1

Application example 1

In the example below, an abnormality occurs with the machine in operation mode, an error
message is displayed, then a previous screen is displayed.
Changeover of the base screen
Word device specifying the changeover destination: D0 (initial value)
Screen No. 1
* MONITOR *
CYCLE
OPERATION
CONTINUOUS
OPERATION
"CYCLE
OPERATION" key
Screen No. 2
ONE CYCLE DRIVEN
• When the program shown in the next page is executed while screen No. 2 or 3 is displayed,
screen No. 10 is displayed by the base screen changeover function.
Screen No. 10
ERROR
MOTOR CHECK
"
To the screen No. 2 or 3
• When the previous screen is to be displayed, as shown in this example, use the upper
hierarchy function on a touch key.
• When the CYCLE OPERATION key is pressed, screen No.
• To return to the previous screen (screen No. 2 or 3) from
"
Changeover of Display Screen (GT Designer) 21
Registered as the common setting for all screens.
2 is displayed. When the CONTINUOUS OPERATION key
is pressed, screen No. 3 is displayed.
Setting of the screen No. 1
CYCLE OPERATION key
CONTINUOUS OPERATION key: Fixed value = 3
"CONTINUOUS
OPERATION" key
CONTINUOUS DRIVEN
screen No. 10, use the upper hierarchy function of a touch
key.
Setting of screen No. 10
PREVIOUS key: Upper hierarchy
: Fixed value = 2
Screen No. 3
21-8