Graphic Operation Terminal GOT-F900
7.
Start up
This section describes the start up procedure from turning ON the power of the GOT to
selection of the mode.
This section also describes the important environment setting to be used in the GOT. Make
sure to read this section carefully.
Substitute from LCD CONTRAST to BRIGHTNESS and read in F940WGOT.
7.1
Start up procedure
This paragraph describes the start up procedure from turning ON the power of the GOT to
selection of the mode.
Perform wiring of the power
supply unit of the GOT.
Connect the PLC.
Turn on the
power without
pressing the
touch key.
The OPENING SCREEN is
displayed.
When there is no screen data
• Perform wiring of the power supply unit of the GOT.
• Connect the GOT and the PLC with an optional connection
cable.
• Turn on the power of the GOT. If the SET-UP screen is
Turn on the
required. When turning on the power press and hold the top
power while
pressing the
left hand corner of the GOT screen for more than 1 second.
touch key.
• The OPENING SCREEN indicating the model name, the
version, etc. is displayed for the period set in "OPENING
SCREEN" in the SET-UP MODE screen.
• In the SET-UP MODE screen, set the required mode, the
The SET-UP
connected PLC name, etc. The operating environment can
MODE screen
is displayed.
also be set in the OTHER MODE screen.
A user screen
is displayed.
Start up 7
7-1