Entry Code - Mitsubishi Electric F930GOT-BWD Operation Manual

Graphic Operation Terminal GOT-F900
14.5

ENTRY CODE

When an entry code is registered in the PLC, changes to the set values of timers and counters
in the screen mode and monitor mode are forbidden. However, the current values can be
changed.
ENTER
Registers an entry code to the PLC.
This entry code is shared by other peripheral units. Enter an 8-digit (FX Series) or 6-digit (A
Series) hexadecimal numeric.
INPUT ENTRY CODE: ¡¡¡¡¡¡¡¡
The entry code becomes effective when the power of the GOT is turned OFF, then turned ON
again.
DELETE
Deletes the existing entry code.
The existing entry code can only be deleted after it was first been entered in the unit.
UNLOCK
Temporarily unlocks the existing entry code. (The entry code is kept registered.)
The unlock function is valid until the power of the GOT is turned OFF.
Note:
When you have forgotten the existing entry code, execute "all clear" in a peripheral unit.
However, have in mind that all of the data including programs in the PLC are deleted by
"all clear". It is recommended not to forget the entry code.
u u u u Basic operation
OTHER MODE
screen is displayed.
Paragraph 7.3
[ ENTRY CODE ]
[ ENTRY CODE ]
ENTER
DELETE
UNLOCK
ENTRY CODE
Select "ENTRY CODE".
Screen 1
Screen1
END [ ENTRY CODE ]
ENTER 0 to F
Enter an entry
code. Screen 2
DELETE 0 to F
Enter the existing
entry code. Screen 2
UNLOCK 0 to F
Unlock the existing
entry code. Screen 2
Screen2
END
ENTER
INPUT ENTRY CODE
0 0 0 0 0 0 0 0
C D E F CLR
8 9 A B
4 5 6 7
0 1 2 3 ENT
Other Mode 14
ENT
Executes
registration.
ENT
Executes
deletion.
ENT
Executes
unlocking.
14-6