Mitsubishi Electric F930GOT-BWD Operation Manual page 51

Graphic Operation Terminal GOT-F900
[ MAIN MENU CALL KEY ]
[ MAIN MENU CALL KEY ]
SELECT CALL KEY LOCATION
[ SET CLOCK ]
[ SET CLOCK ]
DATE 3 / 1 / 1999
TIME 10: 10: 10
5 6 7
0 1 2
[ SET BACKLIGHT ]
[ SET BACKLIGHT ]
OFF TIME
5 6 7 8
0 1 2 3
END
END
8 9 - CLR
3 4 ENT
END
10 MIN.
9 - CLR
4 ENT
• Set the menu call key which changes over the screen
mode (in which a user screen is displayed) to the
SELECT MODE screen.
The menu call key is mesh type, and 2 × 2 in size.
(Initial: On the left)
• One or two corners can be selected among the four
corners of the screen.
• When the menu call key is not set, only the screen
mode is available. Any other mode is not available.
• If another touch key is assigned to the corners to
which the menu call key has been assigned, the menu
call function is disabled.
• Set the time used in the time switch, the sampling
mode and the alarm mode.
• When "DATE" or "TIME" is selected, date or time can
be entered using the ten-key pad displayed at the bot-
tom of the screen. Enter the desired date or time, and
press the ENT key to register it.
• Set the time at which the display backlight turns off.
When a touch key is not pressed or the user screen is
not changed over within the specified OFF time, the
backlight is turns off. (Initial: 10 min)
• When "OFF TIME" is pressed, the OFF time can be
set within the range of 0 to 99 minutes using the ten-
key pad displayed at the bottom of the screen. Enter
the desired time, and press the ENT key to register it.
• The service life of the backlight is 25,000 hours.
• The specified bit of the control device (system informa-
tion) should be set to ON so that the backlight OFF
function is enabled. (Refer to Paragraph 8.6.)
Start up 7
7-7