Table B-11. Default Output Assignment - Thermo Scientific 48i Instruction Manual

Thermo Fisher Scientific
This command reports the index number and output variable and the
active state assigned to output channel. The example below reports the
input 2 to be assigned an index number 2 corresponding to "local/remote"
with the active state being open.
Send: dout 2
Receive: dout 2 2 LOCAL/REMOTE open
set dout channel index state
This command assigns digital output channel to be assigned to the action
associated with index, and assigns it an active state of state (open or closed).
Send: set dout 2 2 open
Receive: set dout 2 2 open ok
dtoa channel
This reports the outputs of the 6 or 12 Digital to Analog converters,
according to Table B–11. The example below shows that the D/A #1 is
97.7% full-scale.
Send: dtoa 1
Receive: dtoa 1 97.7%
Note All channel ranges are user definable. If any customization has been
made to the analog output configuration, the default selections may not
apply. ▲
Table B–11. Default Output Assignment
D to A Function
1 Voltage Output
2 Voltage Output
3 Voltage Output
4 Voltage Output
5 Voltage Output
6 Voltage Output
7 Current Output
8 Current Output
9 Current Output
10 Current Output
11 Current Output
12 Current Output
Single Range Dual Range
CO Low CO
CO High CO
Not Used Not Used
Not Used Not Used
Not Used Not Used
Not Used Not Used
CO Low CO
CO High CO
Not Used Not Used
Not Used Not Used
Not Used Not Used
Not Used Not Used
Model 48i Trace Level-Enhanced Instruction Manual
C-Link Protocol Commands
I/O Configuration
Auto Range
CO
Range Status
Not Used
Not Used
Not Used
Not Used
CO
Range Status
Not Used
Not Used
Not Used
Not Used
B-39