Advertisement
Instrument State
Thermo Fisher Scientific
The Instrument State submenu allows the user to select the instrument
state that is tied to the selected relay output. A submenu lists signal types of
either alarm and non-alarm to choose from.
In the Main Menu, choose Instrument Controls > I/O Configuration >
●
Output Relay Settings > Select Relay > Instrument State.
CHOOSE SIGNAL TYPE:
>ALARMS
NON-ALARM
RANGE
Alarms
The Alarms status screen allows the user to select the alarm status for the
selected relay output. The selected item is shown by "<--" after it.
In the Main Menu, choose Instrument Controls > I/O Configuration >
●
Output Relay Settings > Select Relay > Instrument State > Alarms.
Note The I/O BD STATUS alarm is only present if the I/O expansion
board is installed. ZERO CHK/CAL and SPAN CHK/CAL are only
present if autozero/span check is enabled.
ALARM STATUS ITEMS:
>NONE
GEN ALARM
CONC MAX
CONC MIN
INT TEMP
BENCH TEMP
PRESSURE
RANGE
SAMPLE FLOW
INTENSITY
MOTOR SPEED
BIAS VOLTAGE
MB STATUS
MIB STATUS
I/O BD STATUS
CONC ALARM
ZERO CHK/CAL
SPAN CHK/CAL
AVG
DIAGS ALARM
▲
AVG
DIAGS ALARM
Model 48i Trace Level-Enhanced Instruction Manual
Instrument Controls Menu
<--
Operation
3-41
Advertisement
Troubleshooting
