Advertisement
Connecting
External Devices
Terminal Board PCB
Assemblies
I/O Terminal Board
Thermo Fisher Scientific
"Connecting External
"External Device Connection
"Terminal Block and Cable
"Instrument Controls
For detailed information about troubleshooting a connection, refer to
"Analog Output
Testing" on page 7-27.
5. Plug the instrument into an outlet of the appropriate voltage and
frequency.
WARNING The Model 48i Trace Level-Enhanced is supplied with a three-
wire grounding cord. Under no circumstances should this grounding
system be defeated.
▲
Several components are available for connecting external devices to iSeries
instruments.
These connection options include:
Individual terminal board PCB assemblies
●
Terminal block and cable kits (optional)
●
Individual cables (optional)
●
For detailed information on the optional connection components, refer to
the
"Optional
Equipment" chapter. For associated part numbers, refer to
"External Device Connection
The following terminal board PCB assemblies are available for iSeries
instruments:
I/O terminal board PCB assembly, 37 pin (standard)
●
D/O terminal board PCB assembly, 37 pin (standard)
●
25-pin terminal board PCB assembly, (included with optional I/O
●
Expansion Board)
Figure 2–5
shows the recommended method for attaching the cable to the
terminal board using the included tie-down and spacer.
identifies the connector pins and associated signals.
Devices" on page
2-5
Components" on page
Kits" on page
9-1
Menu" on page
3-23
Components" on page 7-5.
Model 48i Trace Level-Enhanced Instruction Manual
Installation
Connecting External Devices
7-5
Table 2–1
2-5
Advertisement
Troubleshooting
