Table B-15. Default Analog Output Channel Assignments - Thermo Scientific 48i Instruction Manual

Thermo Fisher Scientific
set dout channel index state
This command assigns digital output channel (1-10) to be assigned to the
action associated with index (1-34), and assigns it an active state of state
(open or closed). Use the "list var dout" command to obtain the list of
supported index values and corresponding state. The following example sets
the digital output channel 4 to state 11.
Send: set dout 4 11 open
Receive: set dout 4 11 open ok
dtoa channel
This command reports the outputs of the 6 or 12 Digital to Analog
converters, according to
D/A #1 is 97.7% full-scale.
Send: dtoa 1
Receive: dtoa 1 97.7%
Note If the instrument is in a mode which does not provide a particular
output, and that output is selected, the value will be 0.0.
Note All channel ranges are user definable. If any customization has been
made to the analog output configuration, the default selections may not
apply. ▲
Table B–15. Default Analog Output Channel Assignments
D to A Function
1 Voltage Output
2 Voltage Output
3 Voltage Output
4 Voltage Output
5 Voltage Output
6 Voltage Output
7 Current Output
8 Current Output
9 Current Output
10 Current Output
11 Current Output
12 Current Output
Table B–15. The following example shows that the
Single Range Dual Range
CO Low CO
CO High CO
Not Used Not Used
Not Used Not Used
Not Used Not Used
Not Used Not Used
CO Low CO
CO High CO
Not Used Not Used
Not Used Not Used
Not Used Not Used
Not Used Not Used
C-Link Protocol Commands
I/O Configuration
▲
Auto Range
CO
Range Status
Not Used
Not Used
Not Used
Not Used
CO
Range Status
Not Used
Not Used
Not Used
Not Used
Model 48i Instruction Manual B-51