Setting The Run Mode - Sony MVS-6520 User Manual

By pressing the [EXEC MODE] button to switch the
memory recall section to run mode setting mode, you can
set the operation mode when executing effects.
Executing an effect automatically
1
Press the region selection button corresponding to the
region for which you want to execute, turning it on
(1 p. 248).
2
Enter the number of the register in which the effect you
want to execute is saved, and press the [ENTR] button.
This recalls the effect saved in the register.
3
Press the [RUN] button.
The [RUN] button lights green and the effect is
executed automatically.
Executing an effect manually
In step 3 of the procedure in
automatically" (1 p.
261), operate the fader lever in the
transition control block.
To use the transition control block fader lever as
a keyframe fader
You can also assign the [KF] button functions to a
transition type selection button in the transition control
block (1 p. 327).
Press the [KF] button, turning it on, to execute a keyframe
effect with the fader lever.
Notes
• It is not possible for the [KF] button to be on for multiple
banks (M/E or PGM/PST) at the same time. If you press
the [KF] button in more than one bank, only the last
button pressed remains on.
• If a macro is assigned to the transition control block
fader lever, then while in use as a keyframe fader the
macro is not executed.
Moving to the first keyframe of the effect
Press the [REWIND] button.

Setting the Run Mode

By pressing the [EXEC MODE] button to switch the
memory recall section to run mode setting mode, you can
set the operation mode when executing effects.
"Executing an effect
Specifying the effect execution direction
To specify the effect execution direction, press the
[NORM] button or the [REV] button, turning it on. To
execute the effect so as to obtain the effects of the
[NORM] and [REV] buttons alternately, press the
[NORM/REV] button, turning it on.
When the [NORM] button is lit: The effect is executed
in the direction from the first keyframe to the last
keyframe.
When the [REV] button is lit: The effect is executed in
the direction from the last keyframe to the first
keyframe.
When the [NORM/REV] button is lit: Each time the
effect is executed, the direction reverses.
Executing an effect up to the next
keyframe
1
Press the [STOP NEXT] button, turning it on.
2
Press the [RUN] button.
This executes the effect as far as the next keyframe.
When the [REV] button is lit, it is executed as far as
the previous keyframe.
Repeating an effect
1
Press the [EFF LOOP] button, turning it on.
2
Press the [RUN] button.
This executes the effect repeatedly, from the first
keyframe to the last keyframe.
When the [REV] button is lit, the effect is executed in
the reverse direction.
3
To stop the repeating effect, press the [EFF LOOP]
button, turning it off, or press the [REWIND] button.
Saving Effects
When you recall an effect, the currently recalled effect is
automatically saved in a register. This is called the auto
save function.
You can disable the auto save function in the Setup menu.
By means of the following operation, you can also specify
a register and save an effect in it.
Saving an effect in a specified register
You make register settings in the Flexi Pad.
261
Saving Effects