Sony MVS-6520 User Manual page 272

You can select more than one region.
To select all regions, press [ALL].
3
Press [OK].
4
Select a register.
To select all levels, press [ALL].
5
In the <Attribute> group, press the buttons for the
attributes you want to apply, turning them on.
Carry out the following procedures for each of the
attributes.
For details about attributes and available attributes,
1 "Snapshot Attributes" (p.
To apply cross-point hold attributes
Notes
Applying the key disable attribute (so the key state is not
reflected) to cross-point hold requires a setting in the Setup
menu.
1 "Selecting the Bank to Make the Settings"
For details,
(p. 357).
1
Press [Xpt Hold].
The Xpt Hold (6321.1) menu appears.
The status area shows a list of the currently selected
regions and bus names.
2
Select a bus.
When the region is set to RTR (Router), select a
destination.
To select one or more buses/destinations, press
[Plural] and then select. To select all buses/
destinations, press [ALL].
3
If the region is set to RTR (Router), press [RTR Level
Select].
If RTR (Router) is not selected, skip to step 5.
A window appears for selecting the router level.
4
Press the level for which you want to set the cross-
point hold, turning it on, and press [OK].
To select all levels, press [ALL].
5
Press [ON].
This enables cross-point hold on the selected bus or
buses.
272
Snapshot Operations in the Menus
267).
To apply the effect dissolve attribute
1
Press [Effect Dissolve], turning it on.
2
Set the dissolve duration.
No. Parameter Adjustment
3 Eff Diss Dissolve duration
Duration
To set the duration for a dissolve set as a
temporary attribute effect
Set the following parameter to set the duration for a
dissolve set as a temporary attribute effect in the Flexi Pad.
No. Parameter Adjustment
5 Temp Dur Temporary attribute dissolve duration
To apply the auto transition attribute
Press [Auto Transition], turning it on.
To apply the GPI output attribute
1
Press [GPI Output], turning it on.
2
Set the port number.
No. Parameter Adjustment
4 GPI Out GPI output port number
Port
To apply the clip event attribute
Notes
The following operating procedure can be used only for
the frame memory channels assigned to a user region.
For details about the assignment,
Regions" (p.
346).
1
Press [Clip Event].
The Clip Event menu (6321.2) appears.
2
In the <Frame Memory Select> group, press the
desired button.
On the left of the status area, the name and content of
the selected region (for example, User1) are shown.
On the right, the content of the clip of the current frame
memory is shown.
3
Press [Clip Event], turning it on.
The clip event attribute is applied.
4
To select the clip of the current frame memory, press
[Set].
1 "Setting User