Sony MVS-6520 User Manual page 265

Copying, moving, and swapping data
between effect registers
This section describes the procedure for copying, as an
example. You can move or swap data using the similar
procedure.
1
Open the Effect >Effect 1-99 >Copy/Merge menu
(6223).
The left side of the status area shows the register
number of the copy source, and the right side shows
the register number of the copy destination.
2
Press the region display in the upper part of the list,
and in the selection window select the region.
You can select more than one region.
To select all regions, press [ALL].
Operation between regions
Operation between regions is possible in the following
cases.
• Between M/E-1 and P/P regions
• Between two of the User1 to 8 regions having the
same configuration
• Between two of the DME ch1, ch2, ch5 to 8
(including Global) regions
3
Press [OK].
4
Select the source and destination registers.
To select all registers, press [ALL].
5
To copy without transferring the name, in the <Copy>
group, press [W/o Name], turning it on.
6
In the <Copy> group, press [Copy].
Merging effect registers
1
Open the Effect >Effect 1-99 >Copy/Merge menu
(6223).
The left side of the status area shows a list for the
register to be placed at the back when merged. The
right side shows a list for the register to be placed at the
front when merged.
2
Press the region display in the upper part of the list,
and in the selection window select the region.
You can select more than one region.
To select all regions, press [ALL].
3
Press [OK].
4
Select the register to be at the back and the register to
be at the front after the merge.
5
Press [Merge].
Deleting data from effect registers
1
Open the Effect >Effect 1-99 >Delete menu (6226).
2
Press the region display in the upper part of the list,
and in the selection window select the region.
You can select more than one region.
To select all regions, press [ALL].
3
Press [OK].
4
Select a register.
To select all registers, press [ALL].
5
Press [Delete].
Attaching a name to an effect register
1
Open the Effect >Effect 1-99 >Rename menu (6227).
2
Press the region display in the upper part of the list,
and in the selection window select the region.
You can select more than one region.
To select all regions, press [ALL].
3
Press [OK].
4
Select a register.
5
Press [Rename].
6
Enter a name of not more than eight characters, and
press [Enter].
Notes
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL
COM0, COM1, COM2, COM3, COM4, COM5,
COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7,
LPT8, LPT9
Register Operations in the Menus
265