Key Modify Clear; Blink Function - Sony MVS-6520 User Manual

Assigning a DME output signal as a
monitor signal
1
Open the M/E-1 >Key1 >Processed Key/Resizer
>Monitor menu (1115.1).
In the Key3 and Key4 menu, select [Processed Key]
instead of [Processed Key/Resizer].
2
Press [Monitor Set], turning it on.
3
In the <DME Select> group, select the DME channel
(DME1 or DME2) to be used.
This assigns the selected DME output to DME MON
V and DME MON K.
The lit colors of [DME1] and [DME2] indicate the
DME assignment.
Lit green: DME currently being monitored
Lit amber: DME that can be monitored
Off: DME is not assigned.

Key Modify Clear

A simple button operation or a menu operation returns the
key settings to the initial status settings.
Press [Default Recall] at the lower left of the menu screen,
turning it on, then press the corresponding VF button (VF1
to VF4) to return the key settings to their initial status.
For details about initial status,
Settings" (p.
317).

Blink Function

With the blink function, you can obtain the following
effects.
Key blink: The key is alternately inserted and deleted at
regular intervals. You can set the period of blinking,
and the proportion of each cycle for which the key is
inserted.
Edge blink: The key fill and key edge fill are interchanged
at regular intervals. You can set the period of blinking,
and the proportion of each cycle for which the original
state holds.
The blink settings are in the Transition menu for each key.
Using the blink function
For example, to make settings for key 1 on the M/E-1
bank, use the following procedure.
1
Open the M/E-1 >Key1 >Transition menu (1116).
92
Key Adjustments (Flexi Pad)
1 "Saving User-Defined
2
In the <Blink> group, select [Key Blink] or [Edge
Blink] to set it on.
3
Set the blink parameters.
When key blink is selected
No. Parameter Adjustment
1 Blink Rate Length of blink cycle
2 Duty
Proportion of cycle for which
original state holds
When edge blink is selected
No. Parameter Adjustment
1 Blink Rate Length of blink cycle
2 Duty Proportion of cycle for which key
inserted
Key Adjustments (Flexi
Pad)
EDIT ENBL button
Mode selection buttons
Region selection buttons
Memory recall section
Selecting the bank and keyer
Before carrying out key adjustment, first select the key
adjust mode, then select the switcher bank and keyer.
For example, to adjust key 1 on the M/E-1 bank, proceed
as follows.
1
In the Flexi Pad mode selection buttons, press [KEY
ADJ].
2
Press the [M/E1] region selection button.
Alphanumeric display
Adjustment knobs
Adjustment
knob displays