Sony MVS-6520 User Manual page 280

Executing a Shotbox Function with
Cross-Point Buttons in the 2nd Row
You can use the bank 2nd row for utility/shotbox
operations.
Notes
To use this function, you must first assign the utility/
shotbox function switch button [UTIL/SBOX] to the 1st
row.
For details about the assignment,
Function to 1st Row Buttons" (p.
You can assign any shotbox register to the cross-point
buttons.
For details about the assignment,
Function to 2nd Row Cross-Point Buttons" (p.
1
Press the [UTIL/SBOX] assigned to the 1st row,
turning it on.
2
Press one of the bank switching buttons
switching buttons" (p.
Supports banks 1 to 5, numbered from left to right.
Notes
Banks cannot be selected on the cross-point control
block of the ICP-3000/3016.
3
Press the cross-point button to which the desired
shotbox is assigned.
Shotbox Register Editing
You can carry out the following editing on shotbox
registers.
• Lock: Write-protect the contents of the register.
• Copy: Copy the contents of one register to another
register.
• Move: Move the contents of one register to another
register.
• Swap: Swap the contents of two registers.
• Delete: Delete the contents of a register.
• Name: Attach a name to a register.
The procedures for shotbox register editing are similar to
the procedures described in
(1 p. 264).
Unlike in effect register editing, however, it is not
necessary to specify a region in shotbox register editing.
280
Shotbox Register Editing
1 "Assigning a Bus or
340).
1 "Assigning a
336).
(1 "Bank
276)), to select the bank.
"Effect Register Editing"