Making Dme Gpi Output Settings - Sony MVS-6520 User Manual

When Target is Ch1 or Ch2: Aspect, No Action
When Target is Proc: Format
No Action
For details about "Level Enable," see "Notes" in
"Making Control Panel GPI Input Settings"
(1 p. 337).
1) Cannot be selected on DME1.
Carrying out level settings
To set the low level and high level, first set the trigger type
to "Level," then use the following procedure.
1
In the Engineering Setup >DME >Device Interface
>DME1 GPI Input menu (7344.1), select the action to
be set, and press [H/L Set].
The H/L Set menu (7344.2) appears.
2
Select the setting.
3
To apply the selection made in step 2 when the input
is the GPI high level, press [H Set]. To apply the
selection the input is low, press [L Set].

Making DME GPI Output Settings

This sets the GPI output ports and trigger type, and makes
the action settings.
Notes
There is no GPI output in DME1.
1
Open the Engineering Setup >DME >Device Interface
>DME2 GPI Output menu (7344.6).
The output port selection is fixed at 1.
2
In the <Trigger Type> group, select the trigger type.
Status: Depending on the status, the relay contacts are
closed or opened, or the output is switched
between high and low.
No Operation: The trigger has no effect on the relay
state or output level.
3
Select the action to be set.
4
Press [Action Set] to confirm the action selection.
1)
, Aspect, Level Enable,
Interfacing with External Devices
365