Editing Snapshot Registers - Sony MVS-6520 User Manual

M/E, P/P: Indicates assignment of M/E-1 (ME1), P/P
(P/P).
User: Indicates the User1 (USR1) to User8 (USR8)
assignments.
DME: Indicates assignment of DME ch1 (DME1),
ch2 (DME2), ch5 (DME5), ch6 (DME6), ch7
(DME7), and ch8 (DME8).
Misc: Indicates the Router (RTR) assignment.

Editing Snapshot Registers

You can carry out the following editing on snapshot
registers.
You can use similar procedures also on master snapshot,
wipe snapshot, DME wipe snapshot and key snapshot
registers.
• Lock: Write-protect the contents of the register.
• Copy: Copy the contents of one register to another
register.
• Move: Move the contents of one register to another
register.
• Swap: Swap the contents of two registers.
• Delete: Delete the contents of a register.
• Name: Attach a name to a register.
For details about snapshot register operations,
Register Editing" (p.
Displaying a List of Snapshot
Registers for Editing
You can display a list of snapshot registers including status
information (whether data is present and so on), then carry
out lock, copy, delete, and rename operations.
Displaying the list of snapshot registers
with status information
Press the menu title button at the top left of the Snapshot
menu.
The Snapshot >Status menu (6300) appears.
The status area shows a list of snapshot registers (1 to 99).
For details about lock, copy, delete, and rename
1 "Displaying a List of Effect Registers for
operations,
Editing" (p.
266).
Register name display
For the same number, the register name for the M/E-1
region takes precedence.
If there is no data for the M/E-1 region, then the register
name appears in the sequence P/P >User1 to 8 >DME ch1,
ch2, ch5 to ch8 >RTR.
274
Snapshot Operations in the Menus
1 "Effect
264).
Operations in the Misc >Snapshot
Menu
To limit the snapshot setting to the M/E or PGM/PST
bank, use the Misc menu for each bank.
This section describes an example on the M/E-1 bank.
Recalling a snapshot
1
Open the M/E-1 >Misc >Snapshot menu (1177).
2
As required, press [Bank Sel] to change the bank.
3
Press the button for the number or name you want to
recall.
This recalls the snapshot, and the button you pressed
lights green.
Saving a snapshot
1
Open the M/E-1 >Misc >Snapshot menu (1177).
2
Set the state you want to save as a snapshot.
3
Press [Store].
4
As required, press [Bank Sel] to change the bank.
5
Press the button for the number or name you want to
save.
Applying attributes
To apply an attribute to the snapshot represented by a lit-
green memory recall button, use the following procedure.
1
To apply the cross-point hold attribute, in the
<Attribute Xpt Hold> group select the appropriate bus.