Sony MVS-6520 User Manual page 103

When Pattern is selected
No. Parameter Adjustment
1 Size Pattern size
2 Soft Edge softness
Pattern number
3 Pattern
"Wipe Pattern List" (1 p.
a) 381).
You can also select the pattern in the Matte Adjust
menu by pressing [Mix Pattern Select] and selecting
the pattern in the Mix Ptn Select menu (1154.2).
Press the desired pattern (1 to 24) to select it, and set
the Size and Soft parameters.
5
If you selected Pattern in step 4, if required, the
following modifiers can be added.
If a wipe mix was set, skip to step 6.
When turning [Position] on and setting the pattern
position
No. Parameter Adjustment
Horizontal position
1 Position H
Vertical position
2 Position V
1 p.
a) 103.
When turning [Multi] on and using replications of
the same pattern
No. Parameter Adjustment
1 H Multi Number of repetitions of pattern
horizontally
2 V Multi Number of repetitions of pattern
vertically
Replication layout
3 Invert Type
1 p.
a) 105.
When turning [Aspect] on and setting the aspect
ratio of the pattern
No. Parameter Adjustment
Aspect ratio
1 Aspect
1 p.
a) 105.
When turning [Angle] on in the <Rotation> group
and slanting the pattern
No. Parameter Adjustment
1 Angle Rotation angle of pattern
1 p.
a) 104.
When turning [Speed] on in the <Rotation> group
and rotating the pattern at a constant rate
No. Parameter Adjustment
Rotation speed of pattern
1 Speed
1 p.
a) 104.
6
a)
7
Setting the wipe position (Positioner)
Move the pattern to a desired position.
a)
a)
1
2
3
a)
To return the pattern position to the center of the
screen
a)
In the <Position> group, press [Center].
To move the pattern from its current position to
the center through the course of a transition
In the <Position> group, press [Auto Center], turning it on.
To set the wipe position using the trackball
a)
You can also set the wipe position using the trackball in the
device control block.
1
a)
To adjust colors 1 and 2, turn on [Color1] or [Color2]
respectively, then adjust the following parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
To interchange color 1 and color 2, press the [Color
Invert] button, turning it on.
Positioner Off
Open the M/E-1 >Wipe >Main Modify menu (1155).
Press [Position] in the <Position> group, turning it on.
Set the following parameters.
No. Parameter Adjustment
1 Position H Horizontal position
• Negative values move to the
left.
• Positive values move to the
right.
2 Position V Vertical position
• Negative values move down.
• Positive values move up.
Press the [M/E1] button in the device control block,
turning it on.
The buttons in the device control block are assigned to
the wipe position setting as follows.
Positioner On
Basic Wipe Setting Operations
103