Sony MVS-6520 User Manual page 173

Outputting graphics to the monitor output
connector
In the Graphic menu (4164), press [Monitor Out] to turn it
on.
Graphics are displayed on the device connected to the
monitor output connector.
Notes
It is necessary to assign the monitor output signals of the
MKS-6570 to the processor output connectors in advance.
1 "Assigning Output Signals" (p.
For details,
Canceling Virtual Images
When a transformation is executed with an extreme degree
of perspective, the part of the image which is beyond the
imaginary view point can wrap around and show on the
other side. The wrapped-around portion is referred to as a
"virtual image."
Using the DME menu, you can make a setting to not show
the virtual images.
Canceling virtual images
1
Open the DME >Input/Output >Video/Key menu
(4162).
2
Press [Wrap Around], turning it on.
Virtual image
Applying Special Effects
(Operations Common to
Special Effects)
In this section, explanations of the operating procedures
for individual special effects begin with selections from
the DME menu.
The following are common operations that you must do
prior to selecting from the DME menu.
351).
Turn [Wrap
Around] on
Applying Special Effects (Operations Common to Special Effects) / Applying Special Effects (Edge Effects)
1
In the device control block, select the target DME
channel.
2
In the menu panel, select the [DME] top menu
selection button.
The DME menu appears.
Applying Special Effects
(Edge Effects)
Border Settings
Adding a border
1
Open the DME >Edge >Border/Crop menu (4111).
2
Press [Border], turning it on.
3
Set the following parameters.
Parameter group [1/2]
No. Parameter Adjustment
1 H Simultaneously adjust width of
left and right borders
2 V Simultaneously adjust width of
top and bottom borders
3 All Simultaneously adjust width of all
four borders
5 Density Border density
Parameter group [2/2]
No. Parameter Adjustment
1 Top Border width on top side
2 Left Border width on left side
3 Right Border width on right side
4 Bottom Border width on bottom side
5 Density Border density
Setting the border color
The operation differs depending on whether the MKS-
6570 or MVE- 8000A is used, or whether the MVE-9000
is used.
When the MKS-6570 or MVE-8000A is used
In the Border/Crop menu (4111), press [Border Color],
turning it on, and set the following parameters.
173