Recalling A Snapshot - Sony MVS-6520 User Manual

• When the reference region is M/E-1 or P/P
• When the reference region is other than M/E-1 or P/
P, and effect dissolve settings are possible
2
Apply attributes (1 p. 267)
[TEMP ATTR] button: Set a temporary attribute. Set
this to Off when setting an attribute.
[EFF DISS] button: Apply the effect dissolve
attribute.
[DUR xxx] button: Set the effect dissolve duration
(where "xxx" is the currently set value). When you
press this button, the memory recall section
switches to numeric keypad input mode, and you
can enter the setting value.
[AUTO TRNS] button: Apply the auto transition
attribute.
[XHLD xxx] button: Apply the bus cross-point hold
attribute (where "xxx" is the applicable bus).

Recalling a snapshot

As an example, to recall a snapshot on the M/E-1 bank, use
the following procedure.
1
In the Flexi Pad, press the [SNAPSHOT] button,
turning it on.
This switches the memory recall section to snapshot
operation mode.
The alphanumeric display shows the number of the
last recalled register on the bank.
2
Press the region selection button corresponding to the
region you want to recall, turning it on.
You can select more than one button.
270
Snapshot Operations in the Flexi Pad
with the following buttons.
For details about the method of region selection,
1 "Selecting regions in the Flexi Pad" (p.
Notes
The regions that can be selected simultaneously are
those assigned to the region selection buttons and the
memory recall section buttons
It is not possible to select [MSTR] and other regions
simultaneously. If selected simultaneously, the master
snapshot takes precedence.
The first button pressed is lit green as the reference
region. Subsequently pressed buttons turn amber for
the region select buttons and yellow for the memory
recall section buttons.
Pressing one of the amber or yellow lit buttons, while
holding down the [SNAPSHOT] button, turns the
button green to indicate its corresponding region as the
new reference region.
For details about the precedence order for becoming
1 "Reference region" (p.
the reference region,
The alphanumeric display shows the name of the
reference region and the number of the register
previously recalled for that region.
3
Press the [BANK SEL] button, and select the desired
bank with the register you want to recall.
For details about the method of bank selection,
1 "Banks and Registers" (p.
4
To apply a temporary attribute
[EDIT ENBL] button and then press the [TEMP
ATTR] button; you can now select the temporary
attribute with the following buttons.
[EFF DISS] button: Effect dissolve.
[DUR xxx] button: Effect dissolve duration (where
"xxx" is the currently set value).
[AUTO TRNS] button: Auto transition.
[XHLD xxx] button: Bus cross-point hold (where
"xxx" is the applicable bus).
To apply a temporary attribute with the cross-point
control block buttons, press the following buttons,
turning them on.
Temporary Button to press
attribute to be
applied
A/B bus cross-point [XPT HOLD] button in the
hold background A/B bus
Key cross-point hold [XPT HOLD] button in the key
bus
Key disable [XPT HOLD] button in the key
bus
247).
(1 p. 327).
239).
268).
(1 p. 267), press the
a)
b)